Filter
Top Products
The View Administration Option
Issue 4 August 2006 139
The View Administration Option
If you are using static addressing and encounter problems, use this procedure to verify the
current values of system parameters and file versions.
Note:
Note: Also use the ADDR option to view IP addresses covered in “Static Addressing
Installation” in Chapter 3 of 4600 Series IP Telephone Installation Guide. IP
addresses might have been entered incorrectly. Verify whether you were
provided with correct IP addresses.
If PROCPSWD is administered as indicated in Chapter 4:
Server Administration,
you must type the Local Procedure password after pressing Mute, and before
pressing V I E W.
The 4601and 4601+ IP Telephone do not support static addressing, and
therefore do not support the V I E W command.
1. While the telephone is on-hook and idle, press the following sequence of keys on the
faceplate of the telephone:
Mute 8 4 3 9 # (Mute V I E W #)
Note:
Note: Press the Mute button momentarily. Do not press this key while pressing other
keys. The 4630 IP Telephone does not have a dedicated Hold button. For all
other 4600 Series IP Telephones, pressing the Hold button instead of the Mute
button also works.
The following text displays left-justified at the top of the display:
2. Press the * button at any time during viewing to display the next name and system value
pair from Table 15
. The first pair displays again after the last pair displays.
Press the # button at any time during viewing to terminate the procedure and restore the
user interface to its previous state.
The names and values display in the order shown in Table 15
.
View settings
*=next #=exit