Filter
Top Products
3 Connect the telephone line cord.
Plug one end of the telephone line cord into the jack labeled TEL
LINE on the back of the base. Plug the other end of the line cord
into a modular jack. Make sure the plugs snap firmly into place.
(If you are wall mounting the phone, use the short line cord, and
press the excess cord into the groove on the bottom of the base.)
4 Connect the power cord.
Plug the power adapter into the jack labeled POWER on the back
of the base. Loop the cord through the strain-relief groove and
press the cord into the groove on the back of the base. Plug the
AC adapter on the power cord into an electrical outlet. The
Message Window flashes CL.
NOTE: Connect power to the base unit before placing the
handset in the cradle.
5 Mount the base on the wall. (WALL MOUNTING ONLY)
Hold the base so the mounting knobs on the standard wall jack
will fit into the holes on the bottom of the base. Slide the base
down onto the knobs until it locks into place.
6 Attach belt clip (optional).
If you wish, you can attach the belt clip to the cordless handset,
following the illustrations below. (The handset may not charge in
the face-up position when the belt clip is attached.)
7 Charge the handset battery.
Place the handset face up or face down in the base. The
CHARGING light on the base goes on to show the handset is in
the right position to charge the battery.
For best battery performance, charge the battery at least 12 hours
the first time. After the first charge,the battery will quick-charge
in only six hours.
INSTALLATION
4
To Attach To Remove
9355_book_1ATT 7/12/99 2:25 PM Page 4