Filter
Top Products
Ring Select and Toll Saver
Use Ring Select to select how many times the phone will ring before the
system answers a call. Set for 1 to 7 rings, or set to SA for Toll Saver (Ring
Select comes preset to 4). When you set the system to SA, the system
answers after four rings when you have no new messages and after two
rings when you have new messages.
1 Press c on the base.
2 Press and release s until you hear “Number of rings...”. The
Message Window displays the current Ring Select setting.
3 Press < or > to change the setting.
Audible Message Alert
If you want the base to beep once every 15 seconds to notify you that new
messages have been received, set the Message Alert to on (the Message
Window displays for on and for off).
1 Press c on the base.
2 Press and release s until you hear “Message Alert is...”. The
Message Window displays the current Message Alert setting.
3 Press < or > to change the setting.
Remote Access Code
The Remote Access Code allows you to access features and functions of the
answering system from a touch tone phone. The Remote Access Code is
preset to 500, but you can change it to any three-digit number from 500 to
999 following the steps below.
NOTE: Do not use the same code as the Priority Calling Code. If you set
the Remote Access Code and the Priority Calling Code to the same
number, neither Code will work.
1 Press c on the base.
2 Press and release s until you hear “Remote Access Code is...”.
The system announces the current Remote Access Code.
3 Press < or > to change the first digit. Press s to
move to the second digit.
4 Press < or > to change the second digit. Press s
to move to the third digit.
5 Press < or > to change the third digit. Press s to
save. The system announces the new Remote Access Code.
FEATURE SETUP
10
9355_book_1ATT 7/12/99 2:25 PM Page 10