Filter
Top Products
10 The screen displays the number or call type matched to this
announcement. To change the recording, select RE-RECORD
— OR —
Select DONE. If you have not recorded all Caller Specific Outgoing
Announcements, begin again at Step 4.
NOTE: You do not need to enter the “1”when storing numbers you
usually dial with a 1 prefix.
Reviewing a Caller Specific Outgoing Announcement
1 Press U on the handset.
2 Use the softkey to select DIR.
3 Select ANS SYS.
4 Select OUTGOING.
5 Select REVIEW. The screen displays the first OUTGOING
announcement.
6 Use < or > to display the announcement you want to review.
7 Select OPTIONS.
8 Select PLAY. The system plays the announcement. You can select
STOP to stop playback
— OR —
Select RE-RECORD to change the announcement
— OR —
Press >, then select ANN ONLY, then select CHANGE to turn the
Announce Only feature ON or OFF.
9 Select DONE to exit.
Deleting a Caller Specific Outgoing Announcement
1 Press U on the handset.
2 Use the softkey to select DIR.
3 Select ANS SYS.
4 Select OUTGOING.
5 Select REVIEW. The screen displays the first OUTGOING
announcement.
6 Use < or > to display the announcement you want to delete.
7 Select OPTIONS.
8 Press >.
9 Select DELETE. The announcement is deleted, and the remaining
announcements are renumbered appropriately.
FEATURE SETUP
15
9355_book_1ATT 7/12/99 2:25 PM Page 15