Filter
Top Products
If the caller’s name or phone number is not displayed during
Call Waiting:
• Make sure you subscribe to combined Caller ID with Call Waiting
service.
• The screen may not display the call information if someone is on an
extension phone.
• The Caller ID with Call Waiting feature is inactive during a power
interruption.
• Make sure the battery is charged.
• Make sure Caller ID with Call Waiting is turned on (see the CALLER ID
OPERATION section of this manual).
If speakerphone conversation sounds distorted:
After the phone is powered up, the speakerphone initializes for about 10–15
seconds the first time it is used. Conversation should be clear after this.
If messages are incomplete:
• If a caller leaves a very long message, part of it may be lost when the
system disconnects the call after three minutes.
• If the caller pauses for more that seven seconds, the system stops
recording and disconnects the call.
• If the system’s memory becomes full during a message, the system
stops recording and disconnects the call.
If you have difficulty hearing messages:
Check the volume setting.
If the system does not answer after the correct number of rings:
• Make sure that the two-digit Message Window in the base is on. If it is
off, press O.
• If Toll Saver is on, the number of rings changes to two when you have
new messages waiting.
• In some cases, the system may be affected by the ringing system used
by the local telephone company.
• If the memory is full or the system is off, the system answers after
10 rings.
46
IN CASE OF DIFFICULTY
9355_book_1ATT 7/12/99 2:25 PM Page 46