Filter
Top Products
23
Hold
Press H to put a call on hold. The SPEAKER light flashes.
To return to the call, press H again
— OR —
Press P on the handset
— OR —
Press K on the base
— OR —
Lift the handset of an extension phone on the same line.
Base Ringer Volume
When you’re not using the speakerphone or listening to messages,press
E or e on the base to adjust ringer volume, from 0 (off, BASE
RINGER OFF light goes on) to 7 (highest). The system sounds a sample of
each ringer level. If the volume setting is set to 7 and you press E,
or if it’s set to 0 and you press e, you’ll hear a beep to let you know
you’re already at the maximum or minimum setting.
Page/Intercom
The Page feature allows you to signal someone at the handset from the base.
• Make sure the CHARGING light is not lit on the base.
• Press i on the base. A three-part paging tone
sounds at the handset, and the screen displays PAGE FROM BASE.
NOTE: When the handset is in use or the Ringer is turned off, the Page
and Handset Locator features are inactive.
Handset Locator
This feature is useful if you misplace the handset.
To locate the handset using this feature: Press and hold
i on the base for approximately four seconds. The base
beeps twice when this feature is achieved.
To cancel the Handset Locator feature: Press any button on the
handset or i on the base. This feature turns itself off in
approximately three minutes if you haven’t turned it off before then.
TELEPHONE OPERATION
At the Base
9355_book_1ATT 7/12/99 2:25 PM Page 23