Filter
Top Products
36
Changing Settings
1 Connect with the answering system.
2 Press *9.
3 Press 9 to enter Setup Mode.
4 To change a setting (Select Announcement, Set Ring Select, Set
Audible Message Alert, Change Remote Access Code, Change Priority
Calling Code), press 4 or 6.
5 To save a setting, press 9.
6 Press 5 to exit the Setup Mode.
Reviewing Settings
1 Connect with the answering system.
2 Press 9. The system will announce the current settings.
Exit Remote Access
If you are using a touch tone phone, hang up the telephone. If you are
using the cordless handset, press a.
Audible Signals
Sound: Meaning:
Long ringing Incoming call
Single beep Valid button press
Three-part tone Page
Repeating three-part tone Handset Locator
Two short beeps Handset is out of range
Four short beeps Low battery
Four long beeps Base is busy
Long buzzing tone Error – unsuccessful action
Series of ascending tones Action has been successful
“Chirp”after ring Priority Call
ANSWERING SYSTEM OPERATION
At Cordless Handset or Touch Tone Phone
9355_book_1ATT 7/12/99 2:25 PM Page 36