AT&T 964 Telephone User Manual


 
6 Connect the power adapter to the telephone.
Use only the power adapter provided with this product. To obtain
a replacement, call 1 800 222–3111.
Plug one end of the power adapter into the jack labeled ADAPTER
on the back of the phone.
7 Check for dial tone.
Lift the handset and listen for a dial tone. If you cannot hear a dial
tone, turn to IN CASE OF DIFFICULTY in this manual.
8 Mount the phone on the wall.
Four One-Line Jacks
Modular
Telephone Jacks
Lines 3 and 4
Modular Telephone Jacks
Lines 1 and 2
Standard
Electrical
Outlet
Power Cord
INSTALLATION
13
INSTALLATION
12
9 Plug the power adapter into a standard electrical outlet not
controlled by a wall switch.
10 Initialization.
As soon as you connect the power cord, the system runs a quick
self-test and the screen displays Initializing for about 15
seconds. When the test is complete, the system enters an initial
setup mode (this happens the first time you plug in the unit only)
and the screen displays press PROG to setup your phone.
See SET UP SYSTEM FEATURES beginning on page 15.
Convenience Ports
If you want to connect another device (such as a modem or fax
machine) to the wall jack, you can use the jacks on the phone
labeled AUX. These convenience ports use Lines 3 and 4; a call
picked up on Line 3 or 4 at another extension may interrupt a fax,
modem, or message transmission.
Two Two-Line Jacks
Four One-Line Jacks
Modular
Telephone Jack
Lines 3 and 4
Modular
Telephone Jack
Lines 1 and 2
Standard
Electrical
Outlet
Power Cord
Modular
Telephone
Jacks
Lines 3 and
4 with
Two-line
Adapter
Modular Telephone Jacks
Lines 1 and 2 with
Two-line Adapter
Standard
Electrical
Outlet
Power Cord
Telephone Jack L1/L2
Telephone Jack L3/L4
Telephone Jack Aux L4
Telephone Jack Aux L3