AT&T 964 Telephone User Manual


 
SET UP SYSTEM FEATURES
19
SET UP SYSTEM FEATURES
18
Assign the Line Group for this Phone
1 Press G.
2 Press - until the screen displays LINE GROUP, then press >.
3 Press - or + to select the desired setting.
4 Press S to store your selection.
Turn Auto-Mute On or Off
Choose whether sounds at this extension will be heard automatically in
response to a page (Auto-Mute Off) or only when m is pressed.
Auto-Mute Off permits hands-free conversation and room monitoring;
Auto-Mute On protects privacy.
1 Press G.
2 Press - until the screen displays AUTO MUTE, then press >.
3 Press - or + to select the desired setting.
4 Press S to store your selection.
Set the Dial Mode
1 Press G.
2 Press - until the screen displays TONE/PULSE, then press >.
3 Press - or + to select the desired setting.
4 Press S to store your selection.
Set the Flash Time
NOTE: If you are using this phone within the United States, there is no
reason to change the Flash Time from the default setting (0.7 seconds).
1 Press G.
2 Press - until the screen displays FLASH TIME, then press >.
3 Press - or + to select the desired setting.
4 Press S to store your selection.
Set Delay Ring
NOTE: This feature is for use with Centrex systems only.
NOTE: If you choose to set a delayed ring on a phone with COVM
service, the phone may not ring at all before COVM picks up the call.
1 Press G.
2 Press - until the screen displays DELAY RING, then press >.
3 Press - or + to select the desired setting. (One ring is about six
seconds.)
4 Press S to store your selection.
Turn Line Usage On or Off for Each Line
If you are not using all four phone lines, you need to turn off Line Usage
for the unused lines. If you expand to a third or fourth line, turn Line
Usage back on.
You may also restrict the use of certain lines on this phone to intercom and
paging only by turning off Line Usage for each line to be restricted. When
Line Usage is turned off, that line cannot be used to answer incoming calls
or to make outgoing or transfer calls.
1 Press G.
2 Press - until the screen displays LINE USAGE, then press >.
3 Press - or + until the screen displays the desired line number,
then press >.
4 Press - or + to select the desired setting.
5 Press S to store your selection.
6 Repeat Steps 1-5 to change the Line Usage status for additional
lines.
Assign the Prime Line (Line Preference)
1 Press G.
2 Press - until the screen displays PRIME LINE, then press >.
3 Press - or + to select the desired setting.
4 Press S to store your selection.