Filter
Top Products
Alti-IP 600 Manual 23
Modifying DHCP Settings
Dynamic Host Configuration Protocol (DHCP) automatically assigns IP
addresses to devices when they are connected to the network.
Enabling DHCP
The Alti-IP 600 automatically enables DHCP by default, but you can reset
the protocol if it becomes disabled using the following steps:
1. Press **7+ ENTER button.
2. Use !/" to select Network,thenpresstheEnter key.
3. Scroll to Enable DHCP.
If DHCP is disabled, the option displays as DHCP Enabled NO.
4. Press " (DOWN key) to enable DHCP.
Disabling DHCP
If you do not use DHCP in your network, you can disable DHCP before
manually assigning an IP address to the Alti-IP 600. To disable DHCP, use
the following steps:.
Note: Procedures involving configuring IP settings cannot be completed
when DHCP is enabled in your network.
1. Press **7+ ENTER button.
2. Use !/" to select Network,thenpresstheEnter key.
3. Scroll to Enable DHCP.
If DHCP is enabled, the option displays as DHCP Enabled YES.
GateKeeper
Discovery
Network>GK
Discovery
Set to YES or NO to indicate whether
GateKeeper discovery is enabled. IP
Phone will automatically find
GateKeeper.
Enable NAT Network>Enable/
Disable NAT
Set whether NAT is enabled or
disabled.
NAT Address Network>NAT
Address
Sets the NAT server’s public IP
address.