Alti-IP 600 Manual 12
Notes:
• When the Alti-IP 600 is booted up without the PC port plugged in,
the PC port defaults to 10Mbps.
• If the PC port is to be used, the user should plug in both the LAN
port and PC port before the IP phone is booted.
• The user should reboot the Alti-IP 600 under any of the following
conditions:
— after disconnecting the LAN cable to the phone
— after changing the IP address or DHCP setting
— after rebooting the PC
Note: If the PC is rebooted during a connected call, the voice
path will be interrupted for 4-5 seconds to reinitialize the
TCP/IP protocol stack.
To connect the Alti-IP 600H/600PH:
a. Connect an Ethernet cable from the IP-PBX to the network port on
the phone.
b. Connect the handset to the receiver jack.
c. Connect an Ethernet cable from another network device, such as a
desktop computer, to the access PC port on the phone.
d. Connect the power plug to the AC Adapter port.
4. Configuring Startup Network Settings
If you are using DHCP
, you do not need to configure anything.
Proceed to Step 5.
If you are not using DHCP
, you must configure these network settings
on the Alti-IP 600 after installing the phone on the network:
• Local IP address
• IP subnet mask
• Default gateway IP address
5. Configuring the AltiWare IP Settings
If you are using Gatekeeper Auto Discovery
, you do not need to
configure anything. Proceed to Step 6.
