Filter
Top Products
86 AastraLink RP Phone User Guide
Using Your 6757i CT RP Cordless Handset
Handset Icons and Status Messages
Screen Icons
Status Messages
Handset Keys
Softkeys ( { or })
Your 6757i CT RP cordless handset has 2 softkeys directly under the LCD display.
The softkey menus change depending on the phone’s state, displaying relevant
softkeys only. These softkeys are pre-programmed for the call handling and extension
management features.
Talk /Hold v Key
The Talk/Hold key v
is a multi-purpose key with the following uses:
• To initiate a call by seizing the line or through pre-dial.
• To answer a call during ringing.
• To place a call on hold during an active call.
Pressing the hold key v
while on a call places the call on hold. While a call is on
hold, and if there are no other active calls, the LED flashes at the hold rate and the
display presents the
Call is on hold prompt. In addition, held call reminder tone is
played in the form of a short ring burst (flash ring).
b
Battery Charge State
4 bars for battery full and the battery icon flashes when charging
m
Reception (Radio Link)
On - Within Range: Ready for use
OFF - Out of range/no radio link
h
Feature Key Activation
Indicates the phone is off hook or a call is in progress
p
Silent Alerter
Silent alerter activated
¬
Ringer Volume
This icon is available only when the phone is in idle mode to indicate the
ringer volume level. The box goes from empty to fully black to represent
from off to low to high volume.
l
Receiver Volume
This icon is available only when the phone goes off-hook to indicate the
receiver audio volume. The box goes from empty to fully black to
represent from low to high volume; there are 10 volume levels total.
Directory List
This icon located just above the softkey allows access to the Directory List
feature.
¨
Callers List
This icon located just above the softkey allows access to the Callers List
feature.
Display Message Description
Microphone mute Indicates when the Mute button has been Activated
Out of range Appears briefly when pressing a key if out of range of the
base station