Filter
Top Products
88 AastraLink RP Phone User Guide
Using Your 6757i CT RP Cordless Handset
Battery Charging
The handset is powered by a nickel metal hybrid battery pack, which must be charged
using the provided handset cradle.
To install and charge the battery, do the following.
1. Slide open the cover of the battery compartment.
2. Place the battery pack in the compartment with the connector wires pointing
towards the bottom of the handset.
3. Connect the battery terminal wire to the charging pins located in the compartment
4. Slide the cover of the battery compartment back onto the handset
5. Place the handset, face up, in the charging cradle. The handset should easily slide
into the charging cradle. If it does not, check the battery compartment cover to
ensure it is in the proper position.
To confirm that the battery is charging, check the battery icon symbol on the
handset display to see if the lines inside the icon are flashing left to right.
Note: The battery must be charged for a minimum of six hours prior to initial usage of
the phone.
Handset Battery Indicator & Status
The display provides "at a glance" information on the handset battery.
Note: The handset is designed to recharge the batteries automatically when required
and the handset is placed on the charger stand. The battery icon will not flash and the
handset does not charge every time it is placed on the stand. If a defective battery is
replaced, then the battery Icon is not identified until the new battery is charged for at
least 2 minutes.
Volume Control
The volume key, located on the side of the handset, controls both the receiver and
ringer volume.
Note: The volume key can also be used to adjust the right/left cursor to add spaces or
to erase characters on the display when editing or creating names, key labels etc.
To adjust the receiver volume:
• While on a call, press the top of the key to increase the receiver volume and press
the bottom of the key to decrease the volume. The receiver volume icon on display
indicates the current volume level. In absence of a PBX, the receiver volume
returns to the default setting after each call. However, the PBX directive can direct
the handset default to the volume.
To adjust the ringer volume:
• When the handset is not being used for a call, press the top of the key to increase
the ringer volume and press the bottom of the key to decrease the ringer volume.
The handset ringer sounds on each adjustment to reflect the new setting and the
ringer volume icon on display also show the current level chosen.
dcba The bars indicate the battery charge level — 4 for full, needs
recharging when only 1 bar appear
f The bars flashes when the battery is being recharged on the
charger stand.