Yamaha PJP-50R Conference Phone User Manual


 
SPECIFICATIONS
46
General
Dimensions (W x H x D) .............. 283 mm x 53.6 mm x 297.5 mm
(11.1 in. x 2.1 in. x 11.7 in.)
Weight (excl. AC adapter) ...................................................... 1.4 kg
(3.1 lbs)
Power supply .......................................100 to 240 V AC (50/60 Hz)
Power consumption ...................................................... Approx. 8 W
Operating environment
Ambient temperature ......................................................... 0 to 40°C
(32 to 104 °F)
Ambient humidity ............................20% to 85% (no condensation)
Radio interference standard
............................................................................ FCC Part 15 (US)
EN55022 (EU)
LAN interfaces
• Ethernet ...................................................10BASE-T/100BASE-TX
Protocols ......................................................IEEE802.3/IEEE802.3u
Communication mode ..................................Auto negotiation, fixed
Connectors ................................................................................RJ-45
MAC address ...................................................Indicated on the label
• Polarity ...................................Straight/cross automatically detected
LINE interface
• Connector .................................................................................RJ-11
Audio input/output interfaces
.................................................Stereo analog input/output (1 each)
Connectors ........................................................................Mini-jacks
Audio
Arrayed microphones (directivity controlled)
Zone audio pickup function
Spot audio pickup function
Microphone auto tracking function
Signal processing
3CH adaptive echo canceller
Microphone/speaker array control
Microphone gain control
Communications
Connected locations
.............................Max. 4 locations, in the mesh connection mode
.........................Max. 8 locations, in the cascade connection mode
Audio codec/frequency response (also refer to the table below)
..... G.711 extension original system (fs = 16 kHz)/300 Hz - 7 kHz
......................................................G.711 (µ-law)/300 Hz - 3.4 kHz
.....................................................G.711 (A-law)/300 Hz - 3.4 kHz
.............................................................G.726-32/300 Hz - 3.4 kHz
DHCP and SIP compliance
Time synchronization using the SNTP server
Port number for SIP .......................................................5060 (UDP)
Port number for RTP/RTCP .........................57000 to 57010 (UDP)
Accessories
AC adapter (PJP-PS01) x 1
Power cable x 1
LAN cable x 1
Modular telephone cable x 1
Owner’s manual <Setup Guide> (this manual) x 1
Owner’s manual <Basic Operation Guide> x 1
Warranty card x 1
(For European customers only)
Use the supplied LAN cable to connect a network hub or router
and this unit. If you use a commercially available LAN cable,
select STP (Shielded Twisted Pair) cable.
*Specifications are subject to change without notice.
Transmission bandwidth requirement of the system
Specifications
Note
Transmission bandwidth
(2-location call)
Transmission bandwidth
(3-location call)
Transmission bandwidth
(4-location call)
G.711 Extension
160 kbps for each of
uplink and downlink
320 kbps for each of
uplink and downlink
480 kbps for each of
uplink and downlink
G.711 µ-law
/A-law
90 kbps for each of
uplink and downlink
180 kbps for each of
uplink and downlink
270 kbps for each of
uplink and downlink
G.726-32 60 kbps for each of
uplink and downlink
——