Filter
Top Products
[15] EXPANDING YOUR PHONE
www.uniden.com
EXPANDING YOUR
PHONE
To register an ELX500, TCX450, TCX440, or TCX400 handset, follow the steps
below:
1) Disconnect the AC adapter from the main base.
2) While pressing down find hs, reconnect the AC adapter.
3) On the handset, press and hold # until you hear a beep.
While the handset is registering,
Handset Registering
will appear in the LCD. When
Registration Complete
is displayed, the handset has been registered to the base. If
Registration Failed
appears, please try these steps again.
De-register the Handset
Deregister the handset's ID from the main base unit or the base ID from the
handset. You will usually only deregister the handset if you are moving it from one
base to another, if you are having a problem with your phone or if you need to
change the digital security code. The digital security code is an identification code
used to connect the handset and the base unit. Normally, setting the code is not
necessary. In the rare situation that you suspect another cordless telephone is
using the same security code, you can change the code by de-registering and
reregistering all handsets.
1) With the phone in standby mode, press the MENU soft
key on the handset and select Deregister HS. Then,
press the OK soft key.
Deregister HS?
appears.
2) Press cid/vol/ or redial/p/vol/ to select
Yes
and
then the OK soft key.
When de-registration is complete you will hear a confirmation tone, and
Deregistration Complete
appears.
3) After de-registering the handset, place the handset to the base to register. You
must re-register the handset before you can use it.
>GIKUVGT*5!
;GU
0Q
$#%- &'.'6' 1-