Filter
Top Products
SETTING UP YOUR BROADBAND PHONE [10]
www.uniden.com
SETTING UP YOUR
BROADBAND PHONE
STEP 3: Check Your Broadband Configuration
The UIP165P supports the two most common broadband connection protocols:
DHCP and PPPoE. If your broadband connection uses DHCP, you do not need to
change any settings on the UIP165P. If your broadband connection uses PPPoE,
you will need to enter your user name and password in "STEP 5: Activate your
Packet8 Service" on page 13.
If your broadband provider has given you a static IP address, you will need a special
configuration for your UIP165P. See the User Interface Guide at www.uniden.com/
voip for more information on configuring your UIP165P.
STEP 4: Connect Your UIP165P
Once your account is set up, you can connect your UIP165P.
1) Use the Ethernet cable to connect your broadband modem to the RJ-45 port labeled
INTERNET [WAN]. If you use a switch or a router for your local network, then you can
connect it to the INTERNET[WAN] port instead.
or