Filter
Top Products
www.uniden.com
[ 9 ]GETTING STARTED
B. Install the rechargeable battery pack into the handset
The handset is powered by a rechargeable battery pack.
The battery recharges automatically when the handset
is placed on the base unit.
Charge the handset battery pack for at least 15-20
hours before using your new cordless telephone for
the first time!
To maximize the charge capacity of your battery pack,
DO NOT plug the telephone cord into the base unit and
wall jack until the battery is fully charged.
1) Press down on the handset battery case cover (use
the finger indention for a better grip) and slide the
cover downward to remove.
2) Plug the battery pack connector (red & black wires)
into the small, black jack inside the battery
compartment. (The connector notches fit into the
grooves of the jack only one-way.) Match the wire
colors to the polarity label in the battery
compartment, connect the battery and listen for
a click to insure connection.
3) Make certain you have made a good connection by
slightly pulling on the battery wires to insure that
there is a secure connection. If the battery connector
is not securely connected, the handset will not
charge properly.
GETTING STARTED
!
Use only the Uniden
(BT-905) rechargeable
battery pack supplied
with your cordless
telephone.
Replacement batteries
are also available
through the Uniden
Parts Department at
(800)554-3988, Monday
through Friday from
8:00 a.m. to 5:00 p.m.
or online at
www.uniden.com.