Filter
Top Products
www.uniden.com
BASICS [ 21]
BASICS
• The tone feature only
applies when the dial
mode is set to pulse.
• This special number
can be stored in
a memory location.
This is referred to as
Chain Dialing.
note
Redial
The redial/pause key redials the last number dialed. The redialed number can be
up to 32 digits long.
Handset
Press line 1 or line 2, then press redial/pause.
Or press
redial/pause, then press line 1 or line 2.
Base
Press line 1 or line 2, then press redial/p.
If any key is pressed before
redial/p, the last number will
not redial.
Tone Dialing Switch-over
Some telephone companies use equipment that
requires pulse dialing (sometimes referred to as rotary
dialing). If you need to enter tone dialing digits, you can switch-over to tone
dialing during the call. For example, entering your bank account number after
you have called your bank.
Initially make your call with the pulse dialing mode. Once your call connects,
press
*
/tone/ . Enter the desired number. These digits will be sent as tone
dialing. Once the call ends, the tone mode is canceled and pulse dialing mode
resumes.
Traveling Out-of-Range
During a call, as you begin to move your handset too far from your base unit,
noise increases. If you pass the range limits of the base unit, your call will
terminate within 60 seconds.
The EXI3226 has two
independent last
number redial
memories; one in the
handset, the other in
the base.
tip