Filter
Top Products
www.uniden.com
[ 16 ] GETTING STARTED
D. Choosing the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the
phone lines. However some phone systems still use pulse dialing such as in
rural areas. The default setting is tone dialing. Depending on your dialing
system, set the mode as follows:
1) Press and hold the
flash key on the base until you hear a confirmation tone.
2) To set the dial mode for pulse dialing, press
# on the base. Or to set the
dial mode for tone dialing, press
*
/tone on the base. A confirmation tone
sounds to indicate the setting is complete.
• If you are not sure of your dialing system, set for tone dialing. Make a trial
call. If the call connects, leave the setting as is, otherwise set for pulse
dialing.
• If your phone dialing system requires pulse dialing and you need to send DTMF
tones for certain situations during a call, you may "switch-over" to tone
dialing. (Refer to "Tone Dialing Switch-over" on page 21).