Filter
Top Products
55
lines and should be avoided.
Radio Interference
Radio interference may occasionally cause buzzing and humming in
your cordless handset, or clicking noises in the base. This interference
is caused by external sources such as TV, refrigerator, vacuum cleaner,
uorescent lighting, or electrical storm. Your unit is NOT DEFECTIVE. If
these noises continue and are too distracting, please check around your
home to see what appliances may be causing the problem. In addition,
we recommend that the base not be plugged into a circuit that also pow
-
ers a major appliance because of the potential for interference. Be cer
-
tain that the antenna on the unit is fully extended when needed. In the
unlikely event that you consistently hear other voices or distracting trans
-
missions on your phone, you may be receiving radio signals from anoth
-
er cordless telephone or other source of interference. If you cannot elimi
-
nate this type of interference, you need to change to a different channel.
Finally, it should be noted that some cordless telephones operate at fre
-
quencies that may cause interference to nearby TVs and VCRs. To mini
-
mize or prevent such interference, the base of the cordless telephone
should not be placed near or on top of a TV or VCR. If interference is
experienced, moving the cordless telephone farther away from the TV or
VCR will often reduce or eliminate the interference.
Cordless Telephone Privacy
Cordless telephones are radio devices. Communications between the
handset and base of your cordless telephone are accomplished by
means of radio waves which are broadcast over the open airways. Be
-
cause of the inherent physical properties of radio waves, your communi
-
cations can be received by radio receiving devices other than your own
cordless telephone unit. Consequently, any communications using your
cordless telephone may not be private.
I.C. Notice
Terminal Equipment
NOTICE: This equipment meets the applicable Industry Canada Terminal
Equipment Technical Specications. This is conrmed by the registration
number. The abbreviation, IC, before the registration number signies
that registration was performed based on a Declaration of Conformity in
-
dicating that Industry Canada technical specications were met. It does
not imply that Industry Canada approved the equipment.
NOTICE: The Ringer Equivalence Number (REN) for this terminal equip-
ment is marked on the equipment itself. The REN assigned to each ter
-
minal equipment provides an indication of the maximum number of ter
-
minals allowed to be connected to a telephone interface. The termination
on an interface may consist of any combination of devices subject only to
the requirement that the sum of the Ringer Equivalence Numbers of all
the devices does not exceed ve.
RADIO EQUIPMENT
The term “IC:” before the radio certication number only signies that In-
dustry Canada technical specications were met.
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
“Privacy of communications may not be ensured when using this telephone.”