Filter
Top Products
49
Changing the Digital Security Code
The digital security code is an identication code used to connect the handset and the base unit. Your unit ships from
the manufacturer with a preset security code. Resetting this code is not normally necessary. In the rare situation that
you suspect another cordless telephone is using the same security code or if you are instructed to change this code
by a manufacturer’s Call Center Representative, you can change the code. To change the digital security code:
Reset all handsets (see page 25).
Re-register each handset by following the steps on page 24.
Traveling Out of Range
During a call, as you begin to move your handset too far from your base unit, noise may increase. If you pass the
range limits of the base unit, you hear a beep and see OUT OF RANGE on the display, and then the handset returns
to standby. You may return to the call if you move your handset within the range limits of the base and press
[ /ash] or [ ] within 30 seconds.
Common Issues
If your phone is not performing to your expectations, please try these simple steps rst. If these steps do not solve
your problem, please call our Customer Hotline (see back cover for contact information).
Symptom Suggestion
The charge LED fails to light
when the handset is placed in
the cradle.
Make sure the AC adapter is plugged into the base or the charger (if you
have more than one handset) and wall outlet.
Make sure the handset is properly seated in the cradle.
Make sure the charging contacts on the handset are clean.
•
•
•
The audio sounds weak. Move the handset and/or base away from metal objects or appliances and
try again.
Make sure you are not too far from the base.
•
•
1.
2.