Filter
Top Products
24
Registering Accessory Handsets
If you purchase an accessory handset, you need to register the handset before use. Only one handset can be reg-
istered at a time. Handsets supplied with the phone are registered to the base by the factory. When charged, pre-
registered handsets display a handset ID number. Handsets that have not been registered display MODELS VARY!
CHARGE HANDSET ON THE BASE FOR REGISTRATION OR REFER TO OWNER’S MANUAL
. (If an accessory
handset has ever been registered to a base, you must reset the handset before you can register it to a new base.
See Resetting Handsets on page 25.)
When you register an extra handset to the base, the handset ID will be assigned.
Registering DCX750 Handsets
Before registering the DCX750 accessory or extra handset, the battery pack MUST be charged for 15-20
hours.
Place the extra handset in the main base unit to begin registration.
While the handset is registering, HANDSET REGISTERING
appears on the LCD display. When REGISTRA-
TION COMPLETE appears, the handset has been registered to the base. If REGISTRATION FAILED ap-
pears, please try these steps again.
Registering DCX640 and DCX700 Handsets
For the DCT756, press and hold the registration button on the bottom of the base. For the DCT7565 dual-
keypad base, press and hold [ash] until the charge LED starts to ash.
On the handset, press and hold
[#] until you hear a beep.
While the handset is registering, HANDSET REGISTERING appears on the LCD display. When REGISTRA
-
TION COMPLETE appears, the handset has been registered to the base. If REGISTRATION FAILED ap-
pears, please try these steps again.
1.
2.
3.
1.
2.
3.