Filter
Top Products
42
Uniden MHS550 Radio Owner’s Manual
code), OFF (to remove a previously associated CTCSS
code), or EXIT (to leave this option without taking any
action).
To associate a code with the chosen channel,
highlight ON then press ENTER. You next choose a
code number between 001 and 142.
Use ▲ or ▼ to change the rst blinking single digit on
the screen to either 0 or 1. Press ENTER to move to
the middle digit.
Use ▲ or ▼ to increment or decrement the middle
digit. If the rst digit is 0, then you can select a middle
number between 0 and 9. If the rst number is 1, then
only select a middle number value between 0 and 4
to avoid an error when your entry is complete as the
highest complete code is 142. Press ENTER. If you
decide you must change the rst digit, press MENU to
return to the rst digit.
Use ▲ or ▼ to change the third digit between 0 and
9. Press ENTER when done. The screen changes
back to EXIT and displays the Channel at the top
along with the chosen code number. When the screen
reverts to the operational screen, the CODE OFF
message has been replaced by the code number.
Note: CTCSS codes range between 1 and 142. If you set a
code number outside this range (for example 190), when you
press ENTER to set that number, an error tone sounds to tell
6.
7.
8.
9.
press the enter key
the character then
arrow keys to select
Press the UP or DOWN
0
press the enter key
the character then
arrow keys to select
Press the UP or DOWN
0