Filter
Top Products
58
When the base information is deleted, the handset displays MODELS VARY! CHARGE HANDSET ON THE
BASE FOR REGISTRATION OR REFER TO OWNER’S MANUAL.
Re-register the handset to the base (see
Registering Accessory Handsets on page 19).
If the handset cannot contact the base, it will display UNAVAILABLE. Make sure the handset is in range of the base
and the base is connected to power.
Resetting the Handset Without the Base
If your original base is not available for some reason (for example, it is lost or somehow incapacitated), you can still
reset the handset and use it with another base.
Press and hold
[ ] and [#/ ] for at least 5 seconds.
Move the cursor to select REPLACING BASE and then press
[select/ ]. REPLACE BASE appears.
Move the cursor to select YES, and then press
[select/ ]. You hear a conrmation tone, and the handset
deletes its own base information without contacting the base. The handset displays MODELS VARY!
CHARGE HANDSET ON THE BASE FOR REGISTRATION OR REFER TO OWNER’S MANUAL.
Register the handset to the new base (see
Registering Accessory Handsets on page 19).
Changing the Digital Security Code
The digital security code is an identication code used to connect the handset and the base. Your unit ships from the
manufacturer with a preset security code. Resetting this code is not normally necessary. In the rare situation that you
suspect another cordless telephone is using the same security code or if you are instructed to change this code by a
manufacturer’s Call Center Representative, you can change the code. To change the digital security code:
Reset the handset (see
Resetting the Handset on page 57).
Re-register each handset (see
Registering Accessory Handsets on page 19).
4.
5.
1.
2.
3.
4.
1.
2.