Filter
Top Products
21
Note: The handset rst clears it registration information from the base and then deletes the link to
the base from its own memory. The handset will now display MODELS VARY! CHARGE HANDSET
ON THE BASE FOR REGISTRATION OR REFER TO OWNER’S MANUAL. If the handset cannot
contact the base, it will display UNAVAILABLE. If this happens, see Resetting the Handset Without
the Base on page 58. For instructions on registering the handset, see page 19.
Setting Up the Phonebook
Your handset can store up to 100 names and numbers in your phonebook . Your phone shares memory between
your phonebook and Caller ID entries. Once you store 100 phonebook entries, Caller ID information will not be
stored and will only display at time of new incoming call. When all the phonebook entries are full, you will hear a
beep and MEMORY FULL appears. You cannot store any additional names and numbers unless you delete some of
the existing ones.
You can also use the phonebook entries or speed dial memory to store a group of numbers (up to 20 digits) that
you may need to enter once your call connects. This is referred to as chain dialing. See
Chain Dialing from the
Phonebook on page 29.
Creating Phonebook Entries
To store names and numbers in your phonebook, please follow these steps:
When the phone is in standby mode, press
[ ].
To create a new phonebook entry, move the cursor to select STORE
NEW, and press
[select/ ]. STORE/EDIT NAME appears.
Enter the name for this entry (STORE/EDIT NAME).
Use the keypad to enter a name for this entry; the name can contain up to 16 characters. (See
Entering Text
from Your Handset on page 11 for instructions on entering text.) If you do not want to enter a name for this
entry, your phone will store this entry as <NO NAME>. Press
[select/ ] when you are nished.
1.
2.
3.
Store/Edit Name
｡