Uniden D3288-2 Telephone User Manual


 
English - 25
The corded handset can
make calls but the cordless
handset(s) cannot.
Check the power connection to the base. If the
base is unplugged or the power goes out, only
the corded handset can make and receive calls.
A station can make calls,
but it won’t ring.
Make sure the ringer is turned on.
Make sure Silent Mode is turned off (see p. 17).
A handset is not working.
Charge the battery for 15-20 hours.
Check the battery connection.
The phone keeps ringing
when I answer on an
extension.
You may have to change the line mode. Contact
Customer Service for instructions.
Audio issues Possible solutions
Callers sound
weak or soft.
Move the handset closer to the base.
Keep the handset’s battery fully charged.
Increase the earpiece volume.
There’s a lot of
noise or static on
the line
Check for interference from appliances (microwave
ovens, TVs, etc.) or wireless devices (baby monitors, WiFi
equipment, etc.). Move the handset or base away from the
interference source.
If you use a telecoil hearing aid, turn on T-coil mode (see
p. 11).
If you have any service that uses the phone line, add a DSL
or telephone line filter (see p. 26).
Caller ID problems Possible solutions
Caller ID information does
not display.
Let calls ring twice before answering.
Make sure your Caller ID service is active.
Caller ID displays briefly
and then clears.
You may have to change the line mode. Contact
Customer Service for instructions.
Multistation problems Possible solutions
I can’t transfer calls. Reset all the stations (see p. 27).
Two handsets can’t talk to a caller. See if any station is in Privacy Mode.
A handset says
Unavailable
.
Move the handset closer to the base.
See if any station is in Privacy Mode.
I can’t register a new handset.
Reset the handset (see p. 27).
See if you have 12 registered handsets.
Answering system problems Possible solutions
The answering system does not
work.
Make sure the answering system is on.
Make sure the base is plugged in.
The system won't record
messages.
See if
Record Time
is set to
Announce Only
.
Delete messages (memory may be full).