Filter
Top Products
11
Installing the Phone
12
Changing the dial mode
Your phone can communicate with the telephone network in two different ways: tone dialing or pulse dialing. These
days, most base networks use a method called tone dialing, so your phone comes programmed for tone dialing. If
your phone company uses pulse dialing, you will need to change your phone’s dial mode. If you don’t get a dial tone
or can’t connect to the telephone network, please follow the steps below to modify your phone’s settings:
Press
[Menu/Select].
Select the GLOBAL SETUP menu, and then the DIAL MODE
submenu.
Scroll
[ ] to highlight PULSE.
Press
[Menu/Select]. You will hear a conrmation tone.
If you ever need to change the dial mode back to tone dialing, follow the same procedure, but select TONE in step 2.
NOW YOU ARE READY TO USE YOUR PHONE!
1)
2)
3)
4)
Installing the Belt Clip
Insert the tabs on the sides of the belt clip into the holes on either side of the
handset. Press the belt clip down until it clicks into place. (Tug on the clip to make
sure it’s secure.)
To remove the belt clip, gently pull the tabs out of the holes, then slide the belt clip
off of the handset.
UC517BH(DECT2088) book OM 2.indb11 11 1/9/2008 11:07:36 AM