Filter
Top Products
Step 2: Power Up DKAdmin PC –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
8
DKAdmin/DKBackup
● From C:\280ADMIN\Data, type del *.ntx and press Enter.
● From C:\280ADMIN\XXX.DK, type del *.ntx and press Enter.
● Run ReIndex Files under Options/System Utilities Menu each time before you start to use
DKAdmin.
● Always exit DKAdmin before you turn your computer off.
Step 2: Power Up DKAdmin PC
Note The DKAdmin Hardware Key must be installed on the PC LPT1 port, to enable the
DKAdmin program to be used after it is installed. If you install DKAdmin without the
key, it will not run.
1. Install the DKAdmin hardware key (red) on the LPT1 parallel printer port as shown in
Figure 2.
Notes
● If you wish, you can install a printer on the end of the LPT1 Admin Hardware Key.
● The printer can be installed and used on the LPT1/Admin Hardware Key. But, it is not
necessary to install a printer to enable DKAdmin to be installed or used.
2. Turn on your computer.
KEY LABEL
DKAdmin
IBM Compatible
Personal Computer
Printer
4ELVCH-B
LPT1 Parallel Printer
Connector on Back
Red DKAdmin Hardware Key (required for DKAdmin)
Parallel Printer
CableScrews
Parallel Printer Port
1994
Figure 2 DKAdmin Hardware Connections