Filter
Top Products
––––––––––––––––––––––––––––––––––––––– Important Things to Do After Upgrading to an RCTUE/F Processor
147
DK424 RCTUE/F Upgrade Using DKAdmin
processor, remove the MBJU from DK424 Base Cabinet per Chapter 5 – DK424
Installation in the Strata I/M Manual, and install the RCTUE/F processor).
8. From the programming telephone run Program 91-9 (twice) to initialize the RCTU E/F
processor.
9. From the programming telephone run Programs 03, 76, and 77-1 to set up the TTY
interface port.
10. Turn system power off for five seconds then turn power back on.
11. Continue the upgrade by following the DKAdmin prompts.
12. After DKAdmin upgrades and uploads the customer database, it prompts you to “Perform
Automatic Power OFF/ON”; answer Yes. DKAdmin runs Program 91-2, then prompts
you to receive data to complete the upgrade process; answer Yes. DKAdmin downloads
the upgraded RCTUE/F database and builds the customer file.
The upgrade is now complete.
Important Things to Do After Upgrading to an RCTUE/F
Processor
♦ Using DKAdmin, run Program
*
03 to identify DK424 cabinets.
♦ If installing line and/or station PCBs in slots 07 and 08 of a DK424 expansion cabinet,
circuit line and port numbers in slots that follow will shift. It is recommended you move
the appropriate station and line cables back to the new installed PCBs. This insures that
telephone and line programs match the physical ports and lines.
♦ Do not try to swap or relocate ports in Program 01 or 02 to match port programming to
physical connections.
♦ When using an RCTUE/F processor in a DK424 Base Cabinet, you must remove the
MBJU from between the R11 and RCTU slot of the DK424 Base Cabinet.
♦ In the above configuration, only DK424 Expansion Cabinets provide eight universal PCB
slots (S_1 to S_8). DK280 Expansion Cabinets only provide six universal slots (S_1 to
S_6) in this or any other configuration of RCTU processor and Base Cabinet (see the
Strata I&M Manual for more configuration details).
♦ ACD overflow assignment codes in Programs 14-4, 14-5, and 14-6 have been upgraded to
the new codes in the RCTUE/F.
♦ Station speed dial codes *10-*49 have been upgraded to the new RCTUE/F codes *100-
*139, respectively, in REPALL and Programs 29,
*
29, 39, and 59.
♦ ACD and IMDU/RMDS port numbers have been upgraded to the new RCTUE/F codes in
Programs
*
09 and 71.