Filter
Top Products
Samsung System Administration Guide
DCS-408 & 408i November 2001
32
System Access Codes
The DCS 408/408i telephone system has the following preset (default) feature access
codes. These codes can be used if a key is not available for the feature you want to
use. Standard (single line) telephone users must always dial these codes.
0 Call attendant or system operator 53+grp+0 Out of group
10 + ext. no. Retrieve parked calls 53+grp+1 In group
11 Put calls on and take calls off hold 54+zone Meet Me Page
12 + ext. no. Retrieve calls on hold at another
station
55 + 0 Page all internal zones
13 Door lock release 55 + 1 Page internal zone 1
16 + spd. no. Make speed dial calls 55 + 2 Page internal zone 2
17 Save number and redial it 55 + 5 Page external zone 5
18 Recall dial tone for new call
55 + ∗
All Page
19 Last number redial 56 Meet Me Answer
400 Cancel Do not Disturb 58 DISA alarm clear
401 Set Do Not Disturb 59 Walking class of service
41 Set Message No Ring 600 Cancel all call forwarding
42 + ext. no. Cancel message 601 + ext.
no.
Set Forward All Calls
43 Set/return messages 602 + ext.
no.
Set Forward Busy
44 Busy station/line callback 603 + ext.
no.
Set Forward No Ans
45 Busy station camp-on 604 + ext.
no.
Set Fwd Busy/No Ans
46 Set up a conference 605 + ext.
no.
Set Fwd Follow Me
47 Enter account code 65 Direct (station) call pickup
48 Set programmed station message 66 Group call pickup
49 Send flash to outside line 67 Universal Answer
50 Station hunt group 7x Individual line numbers
to 8 Trunk group
53 Station hunt group 9 Local trunk group
If your system installer has programmed different feature access codes to those shown
above, you can enter these codes in the following ‘Changed System Access Codes’
table for your convenience.