Filter
Top Products
Samsung System Administration Guide
DCS-408 & 408i November 2001
3
Both types of recalls will ring and have a slow flashing amber light on the LINE key or
CALL key.
Executive Barge-In
If you want to break into another station’s conversation, either to monitor the call or join
the conversation, your keyset must be programmed to allow you to barge in, and the
other station(s) must not be secured against barge in. These options must be pro-
grammed for you by the system installer; you do not have customer-level access to the
relevant program. You can then select one of the following barge-in options for your
keyset (see MMC 206):
•
No barge-in allowed
•
Barge-in with tone
•
Barge-in without tone
Barging in on an unsecure station can be done with or without an intrusion tone or dis-
play. If ‘with tone’ is selected, a warning tone and display will be sent to the station. If
‘without tone’ is selected, the station that barges-in can monitor the conversation and
no warning tone or display will be sent to the station being monitored. The handset
transmitter and keyset microphone of the barging-in station are disabled. You can,
however, join the conversation by pressing the MUTE key on the keyset to enable the
handset and microphone.
To barge in:
1. Dial the desired extension number and listen for the busy signal.
2. Press the BARGE key. (If joining the conversation, also press the MUTE key
and begin speaking after the tone).
3. Hang up when you are finished.
Note: If your system supports CLIP information (408i only) you can investigate to see what num-
ber is calling a station, or is being called, before you barge in. See Investigate (ISPY) in the
“CLIP Special Features” section of this guide.
Walking Class Of Service (WCOS)
While away from your desk, you may want to make a call or use features allowed by
your own station but from a station with a more restricted class of service. You can
temporarily change a restricted station's class of service to the same class as your own
station using the following procedure.
1. Lift the handset or press the SPEAKER key.
2. Dial 59 and then your normal extension number.
3. Dial your station passcode
1
and receive internal dial tone.
4. Dial an access code and then the telephone number—OR—use the desired
feature as usual.
5. Hang up when finished. The station will be returned to its restricted status
1
Note: You must change your keyset passcode from the default value (1234) in order to use the
WCOS feature. See your Samsung DCS Keyset User Guide for how to do this.