Filter
Top Products
8
Installation
plate studs and slide the base
downward to secure it.
6. Plug the adapter into a standard AC
outlet.
7. Press and lift out the handset holder, flip
it over, then snap it back into place to
hold the handset.
8. Lift the base’s antenna to a vertical
position.
To mount the phone directly on a wall, you
need two screws (not supplied) with heads
that fit into the keyhole slots on the bracket.
Follow the steps under “On a Wall Plate or
Wall” then apply these additional
instructions.
1. Drill two holes 3
15
/
16
inches apart.
Thread a screw into each hole, letting
the heads extend about
1
/
8
inch.
2. Plug one end of the supplied long
modular cord into the
TEL LINE
jack on
the base’s back.
3. Align the bracket’s
keyhole slots with the
mounting screws and
slide the base
downward to secure
it.
CONNECTING, CHARGING
AND REPLACING THE
BATTERY PACK
The phone comes with a rechargeable Ni-Cd
(nickel-cadmium) battery pack installed in
the handset, but not connected. Before using
your phone, you must connect the battery
pack, then charge it for about 24 hours.
1. Press down and slide off the battery
pack compartment cover.
2. Lift the battery pack out of the
compartment.
3. Plug the battery
pack’s connector
into the socket in
the compartment.
The connector fits
only one way.
4. Put the battery pack in the compartment.
5. Replace the cover.
To charge the battery pack, place the
handset on the base, face up or down. The
base’s CHARGE/IN USE indicator lights.
Recharge the battery pack when
Bemý8Wjj[hoý
Bemý8Wjj[hoýBemý8Wjj[hoý
Bemý8Wjj[hoý
flashes.
Important:
Be sure the battery pack is
properly connected before you try to charge
it. The CHARGE/IN USE indicator lights
when the handset is on the base even if the
battery pack is not connected properly.
Notes:
• When you first use the phone after
charging or recharging the battery pack,
the phone might not work and you might
hear error beeps. If this happens, return
the handset to the base for about 5
seconds to reset the security access-
protection code.
• Using a pencil eraser, clean the
charging contacts on the handset and
the base about once a month.
• If the phone does not work, recharge the
battery pack. (The battery power might
be too low to flash the display.)
• If the battery pack becomes weak during
a call, the handset beeps and
ýBemý
ýBemýýBemý
ýBemý
8Wjj[ho
8Wjj[ho8Wjj[ho
8Wjj[ho
flashes. When this happens, you
cannot make a call on the phone until
you recharge the battery pack.