Filter
Top Products
21
Answering System Operation
and the system announces the day and time
of the call at the end of each message.
To play all messages after playing the new
messages, press
PLAY/STOP
again.
To skip to the next message, press
SKIP
/
;
while the message is playing. Hold down
SKIP/
;
to quickly advance through a
message. The system advances through the
playback at double speed until the end of the
last message. Release
SKIP
/
;
to resume
normal playback.
To replay the current message from the
beginning, press
:
/
REPEAT
. Hold down
:
/
REPEAT
to review the current message. The
system skips back every other second of
playback and plays the previous second,
until the beginning of the message. Release
:
/REPEAT
to resume normal playback.
If you press
:
/REPEAT
within about 2
seconds (4 seconds during remote
operation) after a message begins playing,
the previous message replays. If the current
message is the first new message, the
system plays back from the beginning of the
current message (it does not go back into the
old message group).
ADJUSTING THE VOLUME
To adjust the speaker’s volume, repeatedly
press
VOLUME
8
or
9
on the base. The
volume setting from
&
&&
&
(lowest) to
/
//
/
(highest)
appears.
DELETING MESSAGES
To delete the current message while it is
playing, press
DELETE
. The system beeps.
To delete all messages at once, while
messages are not playing, hold down
DELETE
until the system beeps and
announces “Messages have been deleted.”
&
&&
&
appears.
Note:
You cannot delete new (unplayed)
messages. If you try to delete all messages
at once while you still have new messages,
the system beeps and announces “Please
play back all messages.”
REMOTE OPERATION
While you are away from your home or
office, you can use a touch-tone phone, or a
pulse (rotary) phone with a pocket tone dialer
(available through your local RadioShack
store), to enter your security code and do
any of the following:
• Set the system to answer or not answer
calls.
• Listen to your messages.
• Record a new outgoing message.
• Record a memo.
• Erase messages.
You cannot remotely operate the system
using its handset or another telephone on
the same line.
Setting the Security Code
The two-digit remote operation security code
prevents unauthorized remote access to
your messages. The code is preset to 80. To
change the code to any number from 00 to
99:
1. Press
MENU
three times. The system
announces “Security code,” followed by
the currently set code. The code
appears.
2. Press
SET
.
3. Repeatedly press or hold down
SKIP
/
;
or
:
/
REPEAT
to change the number.
4. Press
SET
to store the setting. The
system announces the newly set code.