Filter
Top Products
7
Installation
• near a modular telephone line jack
• out of the way of normal activities
• away from electrical machinery,
electrical appliances, metal walls or
filing cabinets, wireless intercoms,
alarms, and room monitors
• away from other cordless phones
You can try different locations to see which
provides the best performance.
Cautions:
You must use a Class 2 power
source that supplies 9V DC
and delivers at least 350 mA.
Its center tip must be set to positive and
its plug must fit the phone's DC IN 9V
jack. The supplied adapter meets these
specifications. Using an adapter that
does not meet these specifications
could damage the phone or the adapter.
• Always connect the AC adapter to the
phone before you connect it to AC
power. When you finish, disconnect the
adapter from AC power before you
disconnect it from the phone.
Your telephone connects directly to a
modular telephone line jack. If your
telephone wiring does not have a modular
jack, you can update the wiring yourself
using jacks and adapters (available at your
local RadioShack store), or have the
telephone company update the wiring for
you. You must use compatible modular jacks
that are compliant with Part 68 of
FCC
Rules
.The USOC number of the jack to be
installed is RJ11C (RJ11W for a wall plate).
On a Desk Top
1. Plug one end of the supplied long
modular cord into the
TEL LINE
jack on
the base’s back.
2. Plug the modular cord’s other end into a
modular telephone line jack.
3. Insert the supplied AC
adapter’s barrel plug
into the
DC IN 9V
jack
on the back.
4. Route the adapter’s
cord through the strain
relief slot on the base’s
bottom.
5. Plug the adapter into a standard AC
outlet.
6. Lift the base’s antenna to a vertical
position.
On a Wall Plate or Wall
1. Insert the two tabs
at the top of the
narrow end of the
supplied bracket
into the base’s
upper tab slots,
then press down
on the bracket’s
latches and insert
them into the lower slots.
2. Plug one end of the supplied short
modular cord into the
TEL LINE
jack on
the base’s back.
3. Insert the supplied AC adapter’s barrel
plug into the
DC IN 9V
jack.
4. Route the adapter and modular cords
through the bracket’s grooves.
5. Plug the modular
cord’s other end into
the wall plate jack,
then align the
bracket’s keyhole
slots with the wall
!