Filter
Top Products
Setting Menu Options
28
Setting the Area Code
If you enter a 3-digit area code number in
the “Area Code” option, your local area
code does not appear in the Caller ID
message. For calls received from outside
your local area code, you will see a full 10-
digit number. Ô
1. Press the
MENU soft key. Select the
Global Setup menu, and then the Area
Code submenu.
2. Press the number keypad (
0-9) to enter
a 3-digit area code.
3. Press the
OK soft key. You will hear a
confirmation tone.
Setting the Dial Mode
Sets the dial mode to tone or pulse. Most
phone systems use tone dialing; the default
setting is tone dialing. Set the dialing mode
to match the dialing system used by your
local phone service.
• If you are not sure of your dialing
system, set the unit to tone dialing.
Make a trial call. If the call connects,
leave the setting as is; otherwise set
the unit to pulse dialing.
• If your phone system requires pulse
dialing and you need to send DTMF
tones in certain situations during a call,
you may switch over to tone dialing
(refer to “Tone Dialing Switch Over” on
page 36).
1. Press the
MENU soft key. Select the
Global Setup menu, and then the Dial
Mode submenu.
2. Press
VOL/RING/ or VOL/RING/ to
select
Tone
or
Pulse
.
3. Press the OK soft key. You will hear a
confirmation tone.
Ô NOTES Ô
• If the area code has
already been stored in
memory, the stored area
code will be displayed.
To change it, use the
DELETE soft key and
number keys to enter the
new area code.
• If your calling area
requires 10-digit dialing,
do not program this
option.