Filter
Top Products
Installation
12
• The supplied battery pack should last
for about a year. If the battery pack
does not hold a charge for more than 2
hours after an overnight charge,
replace it with a new 3.6-volt, 800 mAh
battery pack with a connector that fits
the socket in the battery compartment.
You can order a replacement battery
pack through RadioShack. Install the
new battery pack and charge it for
about 15–20 hours.
o
INSTALLING A BELTCLIP
To attach the beltclip
Insert the beltclip into the holes on each
side of the handset. Press down until it
clicks.
To remove the beltclip
Pull either side of the beltclip to release the
tabs from the holes.
USING A HEADSET
You can make or answer calls with hands-
free convenience using an optional headset
that has a
3
/32-inch (2.5-mm) plug.
RadioShack has a variety of headsets
available.
To connect the headset, gently flip open the
rubber headset jack cover on the side of the
handset. Then insert the headset’s plug into
the jack. Ô
Connecting a headset disconnects the
handset’s earpiece and microphone.
VOL/RING/ or VOL/RING/ on the handset
also controls the headset’s volume.
With a headset connected, you can make or
answer calls as usual using the keys on the
handset.
When you finish using the headset,
disconnect it from the handset and close the
rubber cover to protect the jack.
o
WARNING
o
Dispose of the old battery
pack promptly and properly.
Do not burn or bury it.
There is a risk of explosion
if battery is replaced by an
incorrect type. Dispose of
used batteries according to
the instructions.
Ô NOTES Ô
• If you place the handset
on the base to recharge
it while the headset is
connected, be sure the
handset seats properly.
• You can use a handset
holder (available from
your local RadioShack
store) to hang the
handset on your belt for
greater convenience
when using a headset.