PYLE Audio 7505-BTMC75 PDAs & Smartphones User Manual


 
Chapter 7: Peripheral Devices & Accessories
Installation: Chargers And Docking Stations
Ikôn Rugged PDA (Windows Mobile 6.1) User Manual 253
- The plug pins on the extension cord are the same number, size, and shape as those on
the adaptor.
- The extension cord is properly wired and in good electrical condition, and that the
wire size is larger than 18 AWG.
Do not expose the AC adaptor to rain or snow. However, both the CH4000 and CH4004
are designed to accept a wet Ikôn Rugged PDA without harmful effect.
Do not place batteries in the docking stations if they are cold—temperatures below 0°C
(32°F). Allow them to warm up to room temperature for at least 30 minutes.
Do not use a docking station if after an overnight charge, the battery feels warmer than
the charger housing. The dock should be inspected by qualified service personnel.
Do not use a docking station if the battery, while charging, becomes more
than lukewarm.
7.4.2 Installation: Chargers And Docking Stations
When installing a charger or docking station, consider the following guidelines.
Keep chargers and docking stations away from excessive dirt, dust and
contaminants.
Chargers will not charge batteries outside an ambient temperature range of 0° C to
40 °C (32° F to 104° F). It is recommended that the charger or docking station be
operated at room temperature–between 18° C and 25° C (64° F to 77° F) for
maximum performance.
After unpacking your unit:
Visually inspect the charger for possible damage.
Install the IEC power cord and apply power.
7.4.3 Power Consumption Considerations
Check to ensure the mains circuit supplying chargers and/or docking stations is adequate for
the load, especially if several chargers and docking stations are being powered from the
same circuit.
Quad docking station can consume up to 1.9A @ 120 VAC or 1.5 A @ 240 VAC.