PYLE Audio 7505-BTMC75 PDAs & Smartphones User Manual


 
Chapter 6: Settings
Options Tab
Ikôn Rugged PDA (Windows Mobile 6.1) User Manual 179
6.33.2.2 Display Parameters
Scan Result
When this parameter is enabled, the type of bar code and the result of the scan appear on the
screen. Note that this information is only displayed after a successful decode and is visible
only while the scanner trigger is pressed. When the trigger is released, this information is
cleared from the screen.
Scan Indicator
When this parameter is enabled, the laser warning logo appears on the display whenever the
scanner is activated.
Scan Result Time (sec)
The value assigned to the “Scan Result Time (sec)” parameter determines how long the scan
results of a successful scan are displayed on the screen. Time is measured in seconds, and a
value of “0” (zero) disables the parameter. When you choose this option, a dialog box
appears where you can enter a value.
Good Scan Beep And Bad Scan Beep
These parameters determine whether or not the Ikôn emits an audible scanner ‘beep’ when a
good (successful) scan or a bad (unsuccessful) scan is performed. Set these parameters to
either on to enable the beeper or off to disable it.
Soft Scan Timeout
This parameter is used by the SDK “Scan” function (soft-scan: starting a scan session via the
SDK function, instead of a physical user trigger press). The value assigned to this parameter
determines the soft-scan timeout from 1 to 10 sec. (default is 3 sec.).
Scan Log File
If this parameter is enabled, the input barcode and the modified/translated output bar code
are logged in the file \Flash Disk\ScanLog.txt. Keep in mind that if the “Scan Log File” is
enabled, there is a slight performance effect when performing multiple scans since the log
file is written to persistent storage.
Note: To remove the scan result from the screen before the “Result Time” has expired,
point the scanner away from the bar code and press the trigger.