Filter
Top Products
Viewing People and Content
3–7
OTX 300
System
TPX 306M
or ATX 300
System
Two seats are shown on each display.
For TPX rooms, this is the entire room.
For ATX rooms, it depends on how the
integrator set up the room.
The entire OTX 300 room. Two seats
are shown on each display.
OTX 300
System
TPX 204M
or ATX 200
System
The entire TPX 204M room. Two seats
are shown on the center display and two
seats are shown on the left display. The
right display is blank. For ATX rooms, it
depends on how the integrator set up
the room.
The entire OTX 300 room. Three seats
are shown on each display.
OTX 300
System
Traditional
video con-
ferencing
system
(such as a
Polycom
HDX
system)
The people at the far site on the center
display. The left and right displays are
blank.
The center four seats and a portion of
the left and right seats at OTX 300 table.
OTX 300
System
More than
one other
site
(multipoint
call)
In multipoint calls, what you see and what the far site sees depends on a variety of
factors including the number of sites in the call, the types of systems in the call, the
cameras being used, and so forth. If a site is using the VNOC, the VNOC operator
usually configures the layout so that every site sees all the other sites in the call.
The following illustration shows what you would see in an OTX 300 room when in a
multipoint call with two TPX 306M sites and one RPX 200 Series site. The left and
center displays show the TPX 306M sites; the right display shows the RPX 200 site.
If you
make a
call
between
an...
And a/an...
This is what you will see in your OTX
300 room...
This is what the far site will see...
HDX