Filter
Top Products
Troubleshooting
88
Answering System
Problem Cause & Remedy
The Answering System is on,
but incoming messages are not
recorded.
•
The recording time is set to “Greeting only”. Select
“1 minute”, “2 minutes” or “3 minutes” (p. 29).
•
Memory is full. Erase unnecessary messages (p. 71).
• The Answering System is not turned on for the
line you wish to record messages from. Select
the desired line or both lines by pressing [LINE
SELECT] repeatedly, then turn the Answering
System on again
(p. 65)
.
“ ” flashes and the
ANSWER ON indicator flashes
rapidly. No new messages are
recorded.
• Memory is full. Erase unnecessary messages
(p. 71).
You cannot operate the
Answering System from the
base unit or the handset.
•
If another user is listening to messages or the
Answering System is handling a call, you cannot
operate the Answering System. Try again later.
You cannot operate the
Answering System from a touch
tone phone.
• Make sure you entered the correct remote
code (p. 75).
• The Answering System may not respond if the
tones are too short to activate the unit. Press
each button firmly.
•
The Answering System is off. Turn it on (p. 65).
When you play back messages
or turn on the Answering
System, the base unit and
handset announce the wrong
day and time.
• The date and time may be set incorrectly. Set
the date and time again (p. 19).
Caller ID information is not
displayed during message
playback (p. 70).
• Caller ID information will not be displayed
— if a message is recorded by using [MEMO]
(p. 72), or
—
if a call is transferred to the Answering System
and the caller leaves a message (p. 73).
Although you tried to erase all
messages, all messages are
not erased.
•
If you pressed a button to start another operation
before you hear “
No messages
”, erasing is
stopped. Erase messages again (p. 71, 72).
The NEW MESSAGE indicator
still flashes even if you have
listened to all new messages.
• The other line has new messages. Select that
line by pressing [LINE SELECT], then play
back the new messages (p. 67).
• If you selected lines to play back messages,
memo messages will not be played. Play back
messages without selecting lines first (p. 67).
An incoming message recorded
for a line is not played after
pressing [MESSAGE].
• Select the line for that message by pressing
[LINE SELECT], then press [MESSAGE]
(p. 67).
FULL