Filter
Top Products
Useful InformationAnswering SystemTelephone System
19
Programmable Settings
Preparation
For assistance, please call: 1-800-211-PANA(7262)
Date and Time
We recommend you set the date and time so that the unit will announce the day
and time each message was recorded when you play back messages.
• When entering the time, you cannot enter numbers greater than 12. Do not use
military time. (To set 13:00 hours, enter “0100”, and select “PM” in step 4.
)
To confirm the date and time, repeat steps 1 and 2.
• The current date and time are displayed. When finished, press [OFF].
1 Press [MENU].
2 Scroll to “Date and time” by pressing [d]
or [B], then press the soft key ( ).
3 (1) Enter 2 digits each for the month, day and
year. (Ex. To set June 15, 2005, enter
“06 15 05”.)
(2) Enter 4 digits for the time (hour and
minute). (Ex. To set 9:30, enter “0930”.)
• If you enter a wrong number, press the soft key
( ) or ( ), or press [B] or [d] to
move the cursor to the incorrect number. Enter
the correct number.
4 Select “AM” or “PM” by pressing [*].
5 Press the soft key ( ).
• The date and time are set and “E” disappears from the base unit display.
• If the handset beeps 3 times, the date and time were not set correctly. Start
again from step 3.
6 Press [OFF].
The date and time may be incorrect after a power failure. When “E” flashes on
the base unit display, set the date and time again.
For Caller ID service users (p. 40)
• When a call is received, Caller ID information adjusts the date and time if the
time is incorrect.
• Caller ID information will automatically adjust the date and time for daylight
saving time.
• If the date and time have not been previously set, Caller ID information will not
adjust the date and time.
Handset
SELECT
B
Date and time
d
BACK
PLAY
SELECT
f g
Date:
|
12.31.2004
Time:12:00 AM
0-9=Date&Time
@=AM/PM
f g
SAVE
Date:
|
06.15.2005
Time:09:30 AM
0-9=Date&Time
@=AM/PM
f g
SAVE
SAVE