General Features
106 Features Guide
Conditions
None
Programming Guide References
• 2.3 Numbering Plan
– Trunk Busy-out
•2.8SystemOption
– ELCOT / LCOT Busy-out Loop Relay
– GCOT Busy-out Loop Relay
Features Guide References
None
T1 LCO Idle status
(Fixed)
GCO Idle status
(Fixed)
TIE The behavior depends on the Start
Signal Type.
(System Programming)
1. Immediate:
the same as the usual idle status.
2. Wink:
When Wink Mode is selected by the
PBX. When the Central Office
processes an incoming call, it grabs
a CO line to the PBX. But when the
PBX busied out the trunk port, the
PBX does not issue a wink signal.
So the Central Office cannot
complete the call. A reorder tone is
returned to the caller. If the Central
Office is a KX-TD500, the caller
will see on hiss phone display, "CO
Not Assigned."
DID Idle status
(Fixed)
The Specification of Trunk Busy-out On
Card Type The status of Trunk Busy-out set to "On" Note
