Filter
Top Products
76
Remote Operation from a Touch Tone Phone
Setting the Remote Code
The 3-digit remote code prevents unauthorised use of your unit for listening recorded incoming/memo
messages. The remote code is not preset.
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points
to “Setting Base”, then press .
•“Input Command” is displayed.
3 Press .
•“Remote Operation” is displayed.
4 Press .
1
5 Enter a 3-digit remote code number to
set the remote operation ON.
OR
Press to set the remote operation
OFF.
6 Press .
•A beep sounds.
•To change the remote code, repeat from
step 2.
•If 5 beeps sound in step 5, a 3-digit number
was not entered. Start again from step 2 and
enter a 3-digit number.
•If a remote code is not programmed, you
cannot use the unit remotely.
KX-TCD725EM-4(65~85) 01.10.24 14:39 Page 76