Filter
Top Products
24
John Miller
<Enter Phone No>
<Enter Name>
Phonebook
You can store up to 200 caller information in the phonebook. All caller information is automatically
stored by the first word in alphabetical order.
If you received a call from the same phone number you stored with name in the phonebook, the
display will show the caller name and phone number (p. 19).
You can categorise the caller information in the phonebook up to 9 categories, then you can select
one of 3 display backlight colours and one of 20 ringer types for each private category–Private
Category Feature (p. 25). This feature is only available on subscription to Caller ID.
You can make a call with phonebook (p. 32).
Storing Caller Information into the Phonebook
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points
to “New Phonebook”, then press .
•The display shows the number of
remaining phonebook items, then
“<Enter Name>”.
3 Enter a name up to 16 characters with
the dialling buttons, , or .
•To select characters, see page 27.
4 Press .
•“<Enter Phone No>” is displayed.
C
5 Enter a phone number, up to 24 digits.
•If you misdial, press . Digits are erased
from the right. To erase all digits,
press firmly.
6 Press .
7 Press or to select the desired
private category number 1 to 9 or OFF,
then press .
8 While“Save”is at the arrow, press .
•A beep sounds and “Saved” is displayed.
•The display will return to “<Enter
Name>”. You can continue the storing
procedure begin with step 3. To return to
the standby mode, press or wait for
60 seconds.
C
C
•If a pause is required for dialling, press .
A pause can be stored in a phone number
counting as one digit (p. 36).
•You can exit the programming mode any time
by pressing .
•If the display shows“Memory Full” in step
2, the display will return to the standby mode.
You must clear the other caller information in
the phonebook (p. 30).
Enter
New Phonebook
200-Memory Avail
KX-TCD725EM-2(24~37) 01.10.24 14:37 Page 24