Filter
Top Products
Chapter 4
Programmable Function on the Base Unit
63
Reset the Base Unit Settings
1 Press .
2 Press or until the arrow points
to “Setting Base”, then press .
•“Input Command” is displayed.
3 Press , then enter the 4-digit base
unit PIN (p. 55).
0
4 Press .
•A beep sounds.
•The display will return to “Setting
Base”. To return to the standby mode,
press .
• You can exit the programming mode any time
by pressing .
This function enables the base unit to clear the following settings at one time. They will return to their
initial settings.
Input Command
12------------
Ringer mode selection All handsets
Number of rings
(Selected then all handsets)
3
Earth/Time Break Recall Time Break Recall
Flash timing 80m seconds
Pause timing 3 seconds
Function
Initial setting
Call restricted All clear
handset(s)
Call restriction All clear
number(s)
4-digit base unit PIN 0000
Base unit ringer volume 2 (MEDIUM)
Function
Initial setting
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
KX-TCD725EM-3(38~64) 01.10.24 14:38 Page 63