Filter
Top Products
Answering System
62
For product assistance, visit www.globarange.com
For A assistance, visit www.joip.com
Operating the answering
system
*1 If pressed within the first 5 seconds of
a message, the previous message is
played.
Erasing all messages
Press {4} 2 times while the unit is not
being used.
L All messages including voice memos
are erased.
Erasing all messages for the desired
line(s)
1 Press {IP/TEL} repeatedly until the
display shows the desired line(s)
(n and/or m).
2 Press {4} 2 times.
Listening to messages
using the handset
When new messages have been
recorded:
– “New message” is displayed.
– The message indicator on the handset
flashes slowly if the message alert
feature is turned on (page 66).
1 K i 0
L The handset plays new messages
including voice memos.
L When you have no new
messages, the handset plays
back all messages.
2 When finished, press {i}.
Note:
L You can also listen to the messages
as follows:
To play new messages:
K i {#}{3}{2}{3}
To play all messages:
K i {#}{3}{2}{4}
L To switch to the receiver, press {s}.
Calling back (Caller ID subscribers
only)
If Caller ID information was received for
the call, you can call the caller back
while listening to the message.
1 Press M during playback.
L To edit the number before calling
back, press {. Then add or
erase digits to the beginning of
the number by pressing the
desired dial key or ^.
2 Press ].
L The indicated line is selected.
L You can also select the line by
pressing {TEL} or {IP}.
Key Operation
{>}/{<} Adjust the speaker
volume
(during playback)
{<} Repeat a message
(during playback)
*1
{>} Skip a message
(during playback)
{■} Pause a message
– To resume playback,
press {6} (centre of
navigator key).
– To stop playback
completely, press
{■} again.
{4} Erase message
currently playing
GT15xxE.book Page 62 Wednesday, August 1, 2007 11:59 AM