Filter
Top Products
Preparation
29
For product assistance, visit www.globarange.com
For A assistance, visit www.joip.com
Setting the unit before
use
Important:
L To program features by scrolling
through the display menus, see page
47.
L Mainly the direct command method is
used in these operating instructions.
Display language N
The default setting is “English”.
1 {i} i K i {#}{1}{1}{0}
2 {V}/{^}: Select the desired setting.
3 M i {i}
Date and time N
Set the correct date and time so that:
– You can use the alarm function (page
55).
– The unit will announce the day and
time a message was recorded when
you play back on the answering
system (page 61). (BB-GT1520/
BB-GT1522/BB-GT1540)
1 K i {#}{1}{0}{1}
2 Enter the current date, month, and
year by selecting 2 digits for each.
Example: 15 August, 2007
{1}{5} {0}{8} {0}{7}
3 Enter the current hour and minute by
selecting 2 digits for each.
Example: 9:30 PM
{0}{9} {3}{0} i Press s until
“09:30 PM” is displayed.
4 M i {i}
Note:
L If you make a mistake when entering
the date and time, push the joystick
right, left, up, or down to move the
cursor, then make the correction.
IP/TEL line selection
The line selection mode determines the
line selected when you press {s} to
make a call.
– “IP”: IP line is selected.
– “TEL” (default): Landline is selected.
If you dial a A number (page 4)
then press {s} using the handset, the
IP line is automatically selected.
Note:
L You can select a line manually
regardless of the line selection mode
by pressing {TEL} or {IP}.
Handset line selection N
1 K i {#}{2}{5}{0}
2 {V}/{^}: Select the desired setting.
3 M i {i}
Note:
L When you press ] to make a call
(page 32), the set line is selected.
When you call back from the redial list
or caller list, the line indicated by V
(landline) or j (IP line) is selected
(page 32, 45, 62).
Base unit line selection N
1 K i {#}{*}{2}{5}{0}
2 {V}/{^}: Select the desired setting.
3 M i {i}
Available model:
BB-GT1540
GT15xxE.book Page 29 Wednesday, August 1, 2007 11:59 AM