Filter
Top Products
Making and Answering Calls
19
Answer a Call
The flashing LED, accompanied by a ring signal and/or a vibrating handset, notifies you of calls.
The ring signal and vibrator can be disabled. The calling party’s handset number or name is
shown. The name will be shown if the calling party’s handset number is stored in the local
phonebook. When a headset is connected to the handset, the answering button on the headset
can be used to answer the call.
Other answering methods can be specified in the Settings menu. See the Mitel 5624 Wireless
Handset Configuration Guide. The answering methods are Automatically, Loudspeaking, and
Quick answer.
When “Automatically” is enabled, all incoming calls are connected automatically.
Answer a Call
When the signal sounds press to answer the call, or press the soft key to answer the
call in loudspeaking mode. The name/number of the calling party appears if calling line
information is available.
End a Call
Press to end the call.
The duration of the call is shown in the display. The total time of the call can also be retrieved
from the Calls menu > Call time.
During a Call
Additional In-call functions can be added by the administrator.
If the handset is configured in PDM you can call a pre-defined emergency number while the
handset/keypad is locked. During the ongoing emergency call, the "More" soft key is disabled.
Note: Some of these functions are system dependent. The parameters are set up in
PDM. See the Mitel 5624 Wireless Handset Configuration Guide, and the Mitel Portable
Device Manager Installation and Maintenance Guide.