Filter
Top Products
5312/5324 IP Phones User Guide
User PIN (5324 IP Phone only)
A Personal Identification Number (PIN) allows a user to log into a set as a hot desk user or generic
SIP user. It is also used to de-activate the Phone Lock feature. PINs must be from 0 to 8 digits in
length. Only digits (0 to 9) are permitted. The default PIN is blank (length zero).
Users will have one generic PIN that can be used for any required features.
The User PIN initially has a zero length, allowing a user, for example, to unlock a phone using a blank
PIN for Phone Lock. Setting the User PIN on the set requires the PIN to have at least one digit.
To change the User PIN:
1. Press
( MENU ).
2. Press No until "Set User PIN?" appears.
3. Press Yes softkey or the User PIN softkey.
4. At the prompt "Enter Old PIN", enter your old User PIN.
5. Press Enter.
6. At the prompt "Enter new PIN", enter your new PIN.
Use left arrow key to correct mistakes. The PIN can include digits from 0 to 9 only and can be
from 0 to 8 characters in length.
7. Press Enter.
8. At the prompt to verify the PIN, re-enter your new PIN again. The set confirms successful or
failed completion.
9. Press
( MENU ) to end the Menu session.
Trunk Flash
The Trunk Flash feature allows you to access Centrex features (if available) while you are talking on
an outside call.
To flash a trunk while talking on an outside call:
1. Press
( TRANS/CONF ).
2. Dial the appropriate feature access code for a single flash or a double flash.
3. Wait for dial tone.
4. Dial the Centrex feature access code.
29