Filter
Top Products
5312/5324 IP Phones User Guide
To make an Emergency Call using the Line Interface Module line, when the IP connection has failed:
1. Lift the handset.
2. Press the Line Interface Module key that you have programmed.
The set indicates IP FAIL: ANALOG CALL.
3. Dial your Local Emergency Number.
EMERGENCY CALLS WHEN EMERGENCY CALL ROUTING PROGRAMMED
Note: This procedure is in addition to the methods described above.
To make an Emergency Call if Emergency Call Routing is programmed:
1. Lift the handset.
2. Dial your Local Emergency Number (911 or equivalent).
For more information, refer to Using the Line Interface Module.
Phonebook
To use Phonebook:
1. Press
(MENU).
2. Press the Yes softkey when "Phonebook?" appears.
3. Enter the name of the desired party, as follows:
• For each letter in the name, press the appropriate key on the keypad until the letter is shown
in the display. For example, if the letter C is required, press the digit 2 three times.
• Use the <— softkey to correct errors.
• If the next letter in the name is on the same digit key as the previous letter, press the —>
softkey before proceeding.
• If required, press —> softkey to add a space between the first and last name.
4. Press the Lookup softkey.
• If the “Phonebook Lookup – Default to User Location” option is enabled on the system for
your phone, the search is limited to names that share your location; otherwise, the entire
directory is searched.
• If “Phonebook Lookup – Display User Location” option is enabled, after the phonebook
search displays the matching name and directory number, the user’s location is displayed.
The display alternates between the name/number and the location every 2 seconds.
5. If no match exists, edit the original entry, OR
If the Phonebook with Location” option is enabled, press Retry. ALL LOCATIONS? Is displayed.
Press Yes to search the entire directory or press No to search for only names that share your
location. Edit the name and press Lookup.
6. If more than one match is found, press the Next softkey.
7. Do one of the following:
• To make the call, press the Call softkey.
• To edit the entry, press the Retry softkey.
• To exit, press
(MENU).
10